Tulsa concrete guide
Concrete driveways in Tulsa
A driveway is two projects joined at the property line: a slab on your lot and an approach across City right-of-way. Plan both before comparing bids.
Start with what the old driveway is telling you
Walk the existing drive after a heavy rain. Standing water near the garage, a slab edge that rocks under a tire, or a crack that opens wider every August all point to the ground or the drainage rather than the surface. A replacement poured over the same wet, unsupported clay tends to repeat the old failure, so describe these signs when asking for an estimate.
Measure length and width, note what parks on it (a pickup, a trailer, a delivery truck backing in), and photograph the transition at the street. A bidder who sees all of that can say whether the slab needs to be thicker, whether the edges should be turned down, and how much demolition and hauling the price includes.
Width is set by zoning, not taste
In RE, RS, RD and RT districts the Tulsa Zoning Code limits driveways serving homes to half the lot frontage or the Table 55-6 figure, whichever is smaller. Within the right-of-way that means 27 feet on frontage of 75 feet or more, 26 feet at 60 to 74, 22 feet at 46 to 59, 20 feet at 30 to 45, and 12 feet below 30. The figure counts every driveway on the lot added together. Wider needs a special exception.
Off-street parking must be a dustless, all-weather surface; gravel driveways are allowed only in the AG and AG-R districts, outside the right-of-way. The City’s code enforcement brochure also says permits are required to expand parking areas, so widening a drive for a third car is a paperwork question before it is a concrete question.
Ribbon driveways are allowed
Two concrete wheel strips, each at least two feet wide and no more than four feet apart, with grass or gravel between them, count as a driveway under section 55.090-F.4. They use less concrete and shed less water. Inside the right-of-way, though, the drive must be fully paved across its whole width, so the approach is still a solid slab.
The approach follows City standards
Standard 701 shows a residential approach of six-inch Class A concrete over a six-inch Type A aggregate base, with a five-foot-by-five-foot sidewalk panel where the walk crosses the drive. The permit, the inspection call and the fee are covered in the driveway permit field note. Retrieved September 27, 2026.
Nothing on this page is a verdict on your driveway; only someone standing on it can judge the slab and the approach. The quote form sends your measurements and notes to an independent local contractor, who calls back to confirm the scope and the price.
Before you decide
Questions worth asking
How wide can a driveway be on a Tulsa house lot?
In RE, RS, RD and RT zoning, no wider than half the frontage or the Table 55-6 limit, from 12 feet on narrow lots up to 27 feet on lots with 75 feet or more, measured within the right-of-way.
Can I build a gravel driveway in Tulsa?
Only for homes in AG and AG-R districts, outside the right-of-way. Elsewhere the code requires a dustless, all-weather surface, though concrete ribbon strips are an allowed alternative.
Does the part by the street need a permit?
Yes. Driveway work in City right-of-way needs a Right-of-Way Minor Construction permit and an inspection call 24 hours before concrete is placed.